Instantor Cem-PRO™
Instantor Cem-PRO™
Instantor Cem-PRO™The Cement Faced XPS Panel system is a quick, easy to install panel intended for use in overlay applications. It can be installed over solid and timber substrates, providing the floor is solid and level. Consisting of a high-density 20mm Cement Faced XPS (400 kPa) Panel with 16mm pipework laid at 150mm centres, this system is suitable for use with low temperature heating systems.
Where the subfloor meets SR2 standard, a tiled floor covering can be applied direct to the
XPS panels (prior to the installation of tiles the surface should be primed and flexible tile adhesive
used to bond tiles). Alternatively, an interlocking wood finish can be applied directly.
For all other floor coverings, a minimum of 6mm self-levelling compound should be applied
prior to floor coverings.
Key Features
Quick & easy to install
Suitable for use with low temperature heating systems
Lightweight & easy to cut/trim
Low Profile Floor Build-Up
Can be laid over Solid or Timber Floors
Can be bonded to Sub-Floor using suitable flexible adhesive or mechanically fixed using screws and washers if desired
400kPa Compressive Strength allows for increased structural integrity
Omega pipe channels ensuring pipe stays in place when under tension
Cement Face gives a strong bonding surface
Easy management of connection pipes with flow and return pathways integrated into the panel
Available Options
|
Pipe Types Available |
16mm PEX-AL-PEX 16mm 5-Layer PE-RT/EVOH |
|
Typical Pipe Spacings (mm) |
150mm |
Pipework Layout Suitability
Floor Covering Suitability
Seek advice from floor covering manufacturer regarding installation methods prior to installation
Heat Output
Watts per m² at 150mm Pipe Centres
|
FLOW TEMP °C |
TOG RATING / OUTPUT W/m² | |||
| 0 | 0.5 | 1 | 1.5 | |
| 35 | 71 | 65 | 59 | 53 |
| 40 | 79 | 72 | 64 | 60 |
| 45 | 85 | 80 | 71 | 65 |
| 50 | 96 | 86 | 78 | 70 |
Installation & Technical Guides
Scan here to explore the system and access installation and technical guides.
